Home Improvement – Build an Awning
How to build an awning
An awning may be a wonderful addition to an outdoor space directly connected to any home. It can be very appealing and can add a beautifying touch to any house, but, most notably, it is a productive way to get shade on very hot summer days. Buying an awning will cost you a considerably amount of money, therefore it may be a wise choice to attempt doing this yourself.Building an awning is not an exceptionally difficult task to undertake and may be even less time consuming if you receive the assistance of someone willing and competent. If you are able to use a standard sewing machine then you will find it even easier to accomplish this job.
Required Tools
Sewing machine with a large needle
Electric drill
Measuring tape
Pliers
Required Materials
2 key rings
2 support poles
2 screw hooks
4 grommets
4 stakes
4 sections of rope
Large piece of canvas
Instructions
Before you go ahead with building and installing your awning you will need to decide on the actual location you will use when erecting your awning. When you have completed that you can then measure the area and consider how large you will be making your awning based on the style you would like to use. You should not be precise with the measurements when buying your material because you will need to allow extra cloth for your hem.
When you have obtained your material you will need to sew a hem around it using your sewing machine to enhance its durability by preventingthe threading at the edge from unwinding. The best type of thread to use is one made from nylon which is more resilient in outdoor conditions. After you have carefully hemmed the complete section of canvas you will then be able to install a grommet on each of the corners of your awning.
You will need to get your measuring tape again and take a measurement of the awning from the grommet to grommet. You will have to utilize these measurements to figure out where you should drill your two pilot holes. Mark the area on your wall or wood siding and drill the holes that show the specific area where the awning will join your existing structure.
You will now have to screw the hooks into the pilot holes but be sure that the holes have been properly drilled to make this possible or at least less hard to carry out. You may utilize your hands to do this additionally utilise a pair of pliers to fasten it more firmly.
For the section of your awning that will be directly affixed to your home you may have to install a key ring on the individual grommet. You may then hook one of the key rings to the hook and then do this once more for the other hook. This may be simpler if you are deriving some assistance from another person who will can put up the other ring while you are installing one on your side.
You will need to stretch the awning so you can figure out where to place the support poles. The poles may be put in the ground or on a flat base that you have made for it to be erected upon. You will then need to run the top of the pole directly through the grommet of the awning.
Get a section of rope and tie it to two of your grommets that currently have the poles running through them. You will then need to stake one portion of rope away from each awning pole and then take the other portion of rope and place it perpendicular to the initially installed stake. This will mean that the poles will have lines that are supporting it to the sides and front. This is another point where a little help will be essential.
Tips
When looking for fabric be sure to think about the colours currently on your house. It would possibly be best to buy a colour that will match any colour you may decide to paint your house in future.
Once utilizing your drill be certain you are not near any open water sources like puddles.